What are the settings on my Shot Scope device?

The following article will explain what are included in the settings for V2 watch.

To access the settings section of the watch follow these instructions:

1) Switch the watch on by pressing the top left button.

2) Unlock the watch by pressing the bottom left button.

3) Press the bottom left button and this will take you into the settings section of the watch.

The different settings are:

Courses - shows the list of courses that have been downloaded onto the watch.

Units - You can see whether your watch is set to yards or meters.

Putting- You can see if your putting mode is set to automatic or manual.

Tag Read- This is a diagnostic tool we have added to test whether a tag is being detected by the watch within the recommended 8-10cm range of the tag.

About - You can check what firmware you have installed and the serial number of the watch.